 |
 |
Press and hold the power key to power on the device |
During power on,The device display the CUB logo.
Software revision number
follows after the CUB logo.
Now the device is at the maker selection menu
 |
Use arrow key to scroll up and down between maker |
Maker selection: Use the arrow key to browse alphabets of
car-makers, press the "Enter" key to select
Maker selection:
Use the arrow key to browse automakers,
press the "Enter" key to select
Model Selection:
Use the arrow key
to browse models, press the "Enter" key to select
| This function is designed for you to bypass OBD II and automatically duplicate an O.E Sensor. |
Maker selection:
Use the arrow key
to select year and frequency and press the "Enter" key to select
Function selection:
Use the arrow key
to select new sensor and press the " Enter " key to select
| NOTE - Duplicate and Program function will only work with CUB's Uni-sensor and Uni-sensor only. |
Function selection:
Use the arrow key
to select program blank sensor and press the "Enter " key to select.
Note : Make sure the correct sensor is inserted in the cradle.
Note : Make sure the correct sensor is inserted in the cradle.
Program Blank Sensor:
Sensor AID will now program the sensor for you, following by Erasing Flash ,Program sensor and Verifying.
Program compelete:
When the Program process is complete, you will hear 2 short beeps when the sensor is programmed.