Press and hold the power key to power on the device
During power on,The device display the CUB logo.
Software revision number follows after the CUB logo.
Now the device is at the maker selection menu
Use arrow key to scroll up and down between maker
Maker selection: Use the arrow key to browse alphabets of car-makers, press the "Enter" key to select
Maker selection: Use the arrow key to browse automakers, press the "Enter" key to select
Model Selection: Use the arrow key to browse models, press the "Enter" key to select
This function is designed for you to bypass OBD II and automatically duplicate an O.E Sensor.
Maker selection: Use the arrow key to select year and frequency and press the "Enter" key to select
Function selection: Use the arrow key to select new sensor and press the " Enter " key to select
NOTE - Duplicate and Program function will only work with CUB's Uni-sensor and Uni-sensor only.
Function selection: Use the arrow key to select manual duplicate and press the "Enter" key to select.
O.E ID Locator: Use the O.E ID Locator to help find the Sensor ID on a dead O.E sensor. press the "Enter" key to select
Manufacture Selection: Use the arrow key to select the manufacturer of the O.E sensor. press the "Enter" key to select
ID Locator: This will show you where the ID is located some manufacturer may have more than one type of sensors. Use the arrow key to browse, to go back press the Esc key
Input ID: Use the Input ID function will allow you to input the ID from O.E Sensor to program the Uni-sensor, press the "Enter" key to select
Input Sensor ID: Use the arrow key to browse, press the "Enter " key to enter the ID Please check if OE sensor ID is Hexdecimal (0~9 + A~ F ) OR Decimal (0~9) to select correct mode in Manual Duplicate.
公司地址: 彰化縣福興鄉彰鹿路六段546巷6號    電話: 886-4-778-2010, 777-0256   傳真: 886-4-778-2009,  886-4-778-3867
Copyright © 2013 CUB ELECPARTS INC. All Rights Reserved.    電子信箱: sales@cubelec.com.tw |  WEBmail  |  Supply Chain