Press and hold the power key to power on the device |
During power on,The device display the CUB logo.
Software revision number
follows after the CUB logo.
Now the device is at the maker selection menu
Use arrow key to scroll up and down between maker |
Maker selection: Use the arrow key to browse alphabets of
car-makers, press the "Enter" key to select
Maker selection:
Use the arrow key to browse automakers,
press the "Enter" key to select
Model Selection:
Use the arrow key
to browse models, press the "Enter" key to select
This function is designed for you to bypass OBD II and automatically duplicate an O.E Sensor. |
Maker selection:
Use the arrow key
to select year and frequency and press the "Enter" key to select
Function selection:
Use the arrow key
to select new sensor and press the " Enter " key to select
NOTE - Duplicate and Program function will only work with CUB's Uni-sensor and Uni-sensor only. |
Function selection:
Use the arrow key
to select program blank sensor and press the "Enter " key to select.
Note : Make sure the correct sensor is inserted in the cradle.
Note : Make sure the correct sensor is inserted in the cradle.
Program Blank Sensor:
Sensor AID will now program the sensor for you, following by Erasing Flash ,Program sensor and Verifying.
Program compelete:
When the Program process is complete, you will hear 2 short beeps when the sensor is programmed.
產品客服中心免付費專線:0800-001-282 服務時間:10am-16pm |
Copyright © 2013 CUB ELECPARTS INC. All Rights Reserved. 電子信箱: sales@cubelec.com | WEBmail | Supply Chain |